Device ID and access token
Every device signs in with two values of its own. A leaked token affects one device only, and you can replace it at any time.
Where to find them
Open the device and go to its Settings tab. The Device ID is always shown there. The access token is shown once, when it is made: copy it into your device code or keep it in a password manager. To get one, or a new one, use Regenerate under Access token.
| Value | Treat it as |
|---|---|
| Device ID | An identifier. Safe to show in logs and to share with your team. |
| Access token | A password for that one device. Never put it in public code or screenshots. |
Replace a token
- 1
Regenerate
On the device's Settings tab, under Access token, choose Regenerate. You confirm with a code sent to your email.
- 2
Copy the new token
It is shown once. The old token stops working immediately, so a connected device disconnects.
- 3
Load it on the device
Put the new token in the device code and load it over USB, or send it with the next web request if the device reports that way.
The device goes offline
A board running the old token cannot receive remote updates once it is disconnected. For equipment you cannot reach with a cable, plan the visit before you regenerate.
Something unclear or out of date on this page? Tell support.
